Table of Contents
Advertisement
Displayed measurements
Ventilation progress curves
EN
Operation
52
During ventilation, the following parameters are displayed
as numbers:
– O
i: inspiratory O
2
unit
– Vt
: expiratory tidal volume/breath volume
e
– f/(fsp): respiratory rate/number of spontaneous
breaths per minute and the corresponding alarm
limit
– MVe: expiratory minute volume and the
corresponding alarm limits
– etCO
: end-tidal CO
2
units equipped with optional CO
and the corresponding alarm limits.
If you deactivate CO
configuration menu, the CO
in red.
If you select two curves and measurements for your curve
display, you will be shown the following measurements in
the display:
– pPeak: Peak pressure in mbar
– pPlat: Plateau pressure in mbar
– pMean: Mean pressure of all measurements in
mbar
– Vleak: Leakage in % Vt
For the purpose of monitoring ventilation, the standard
unit displays the following parameters as curves:
– Pressure, flow
– Pressure, flow, measurements
– Pressure gauge (only in volume-controlled modes)
concentration measured by the
2
concentration (only with
2
measurement)
2
suction in the Options | CO
2
display is crossed out
2
i
2
Advertisement
Table of Contents
