View Measurement Data File; Load Settings; Create Average - Larson Davis SoundAdvisor 831C Reference Manual

8.3.1 View Measurement Data File

FIGURE 8-5 Data File Icon

8.3.2 Load Settings

Ensure that you
TAKE NOTE
save your current settings
before loading. You will lose
any settings you had on the
Active setup. On how to do
this, see "User Defined
Setup" on page 6-9.

8.3.3 Create Average

SoundAdvisor Model 831C
Navigate Menu Data File Manager Highlight desired data file 
Menu View.
A read-only display of the Overall and Session Log tabs will show the
data from that measurement. To indicate that you are seeing a
measurement data file and not the live data, the data file icon will
appear next to the data file name.
A saved data file's settings can be loaded to the Active setup to be used
for a measurement.
Stop any measurement currently running or paused before loading the
new settings. Navigate to Menu  Data File Manager  Highlight
desired data file Menu Load Settings.
There is no indication that the settings were loaded, so it is encouraged
to review the Active setup after loading. Close the Data File Manager,
navigate Menu 
settings.
Create Average takes a saved data file and adds its average as an
instance to the unsaved Overall measurement.
• Any unsaved measurement will be overwritten with the new
average instance.
• You can add multiple files to the average and each appears as a
new instance in the overall measurement. However, each file
can only be added once.
• A measurement can run after the averages are loaded, though
not recommended for averaging purposes.
• After data files are averaged, you can save the new data as a
single file.
Follow these steps to create an average of your data file(s):
Step 1 Navigate to Menu Data File Manager.
Data File Manager
Setup Manager then cycle through the Active
8-4