Email - Larson Davis SoundAdvisor 831C Reference Manual

9.11 Email

Email alerts can be
TAKE NOTE
enabled on a Event History
setup, see "Setting up the
Measurement" on page 17-1.
Once enabled, the email
preferences from System
Properties will be used for the
alerts.
FIGURE 9-17

Email

The email server
TAKE NOTE
that the SoundAdvisor
connects to needs to be SMTP
server with TLS
authentication (using port
587). When setting up an
email account through a
public server (i.e. Gmail or
Yahoo), you may need to
enable SMTP access for the
account, typically through
secure login settings. To avoid
spam filters, add the host
email addresses to your
contact list.
9.11.1 Enable Email Alerts for Noise Events
SoundAdvisor Model 831C
The SoundAdvisor with a network connection can be setup to send
email and/or text alerts for sound events and other features. When SPL
2 trigger is exceeded during a measurement, as well as noise that
exceeds the PEAK 3 trigger will initiate an alert. Email is also used for
cloud storage notifications, see "Cloud Storage" on page 9-13.
To set up email alerts, follow these steps:
Step 1 Navigate System PropertiesEmail.
Step 2 Enter an email hostname, username, and password.
Step 3 Enter the email addresses the recipients will reply-to.
Step 4 Indicate the email address for the text alert. For this field,
the phone number @ carrier email address will be
accepted. For example, 80155555555@vtext.com will send
a text message to a Verizon Wireless mobile device.
Step 5 Send a test email.
If an email or text does not deliver within a few minutes of initiating a
test, check to see if your meter is connected to the internet and a proxy
is not filtering your alerts. Contact your local IT support for more help.
Step 6 Save and Close.
Step 1 Enable email alerts on an Event History setup, and make
active. See "Setting up the Measurement" on page 17-1.
Email 9-11