Default To Ld Default Setup; User Defined Setup - Larson Davis SoundAdvisor 831C Reference Manual

6.3 Default to LD Default Setup

6.4 User Defined Setup

Use the Setup
TRY THIS
Manager in G4 LD Utility to
manage setups, store setups,
and transfer them to and from
the SoundAdvisor.
If settings are
TAKE NOTE
changed in the Active setup,
they will not be saved in your
new setup. Change settings
on your setup, then set to
Active for optimal operation.
SoundAdvisor Model 831C
The Default setup is the factory measurement settings for the
SoundAdvisor. It is read-only and cannot be deleted. If set to Active, it
will restore the settings to the factory default values.
To set to active, navigate to the Setup Manager through either the Tools
Menu or Main Menu and then select the Default setup by pressing enter.
Then select Set to Active.
While measurements can be made by defining values on the Active
setup, you can also save all your settings in a user-defined setup. The
setup can be stored and called to Active at anytime. This setup can be
transferred to a PC, and then transferred to a different SoundAdvisor as
well.
Follow these steps to create a user-defined setup:
Step 1 Navigate to any menu on the SoundAdvisor (Tools or
Main), then select Setup Manager.
Step 2 Select the Active setup.
Step 3 Select Save As.
Step 4 Enter name of your setup. Select OK.
Step 5 Your setup can be made Active by selecting and Set to
Active.
To know which setup you are making changes to, see the top right of
the screen to see the name of your setup:

Default to LD Default Setup

6-9