Setup Manager - Larson Davis SoundAdvisor 831C Reference Manual

6.2 Setup Manager

If the SoundAdvisor
TAKE NOTE
is connected to G4, when you
load the Setup Manager, a
dialogue box may appear
"Setting in use by another
connection. Continue?" If you
create a setup or make
changes on the meter, Refresh
List in G4 to sync changes.
FIGURE 6-1

Setup Manager

The Active setup is
the measurement
settings currently
active on the
SoundAdvisor.
The Default setup will
restore all active
properties to the
factory default
values. It is Read-
Only and cannot be
SoundAdvisor Model 831C
All the measurement settings can be found in the Setup Manager. It can
be accessed by going to any menu and then selecting Setup Manager.
The first page displays the Setup Files (setups) currently saved on the
meter. Active and Default will always be present on the meter.
The settings are organized into tabs that can be accessed using the left
and right softkeys from the main Setup Manager view. Navigate back to
the Setup Manager page to be prompted to save or discard any changes
made.
The first page of the Setup Manager shows all saved setup files
currently on the SoundAdvisor. Any other setup files listed may be
activated, edited, and/or deleted. To activate a setup file, select the
setup file and choose Set to Active.
Before defining any settings or settings values in a setup, it is good
practice to set the Default to Active to clear any user defined settings.
See "Default to LD Default Setup" on page 6-9.
Setup Manager
Navigate to the
settings pages by using
the top left and right
softkeys. The pages to
the right and left are
indicated at the
6-2