Configuring Received/Redistributed Route Filtering; Configuring A Preference For Rip; Configuring Rip Route Redistribution - HP 6125XLG Configuration Manual

Configuring received/redistributed route filtering

Perform this task to filter received and redistributed routes by using an IP prefix list. You can also configure
RIP to receive routes only from a specified neighbor.
To configure route filtering:
Step
1. Enter system view.
2. Enter RIP view.
3. Configure the filtering of
received routes.
4. Configure the filtering of
redistributed routes.

Configuring a preference for RIP

If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest priority
is selected as the optimal route. Perform this task to assign a preference to RIP. The smaller the preference
value, the higher the priority.
To configure a preference for RIP:
Step
1. Enter system view.
2. Enter RIP view.
3. Configure a preference for
RIP.

Configuring RIP route redistribution

Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF, IS-IS,
BGP, static, and direct.
To configure RIP route redistribution:
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
filter-policy { acl-number | gateway
prefix-list-name | prefix-list
prefix-list-name [ gateway
prefix-list-name ] } import
[ interface-type interface-number ]
filter-policy { acl-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] | interface-type
interface-number ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
preference [ route-policy
route-policy-name ] value
27
Remarks
N/A
N/A
By default, the filtering of
received routes is not configured.
This command filters received
routes. Filtered routes are not
installed into the routing table or
advertised to neighbors.
By default, the filtering of
redistributed routes is not
configured.
This command filters redistributed
routes, including routes
redistributed with the
import-route command.
Remarks
N/A
N/A
The default setting is 100.