Setting Up The Switch As A Stand-Alone Unit - HP StorageWorks SAN Switch 2/32 Installation Manual

Installing the SAN Switch 2/32
Setting Up the Switch as a Stand
Use these procedures for setting up the switch as a stand-alone unit. The following
items are required for this setup:
• SAN Switch 2/32
• AC power cords and cables supplied with the switch
• Rubber mounting feet supplied with the switch
1. Place the SAN Switch 2/32 on a flat, sturdy surface like a table or lab bench.
2. Apply the rubber feet as follows.
a. Clean the four depressions that are at each corner of the bottom of the switch
to ensure they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against the
chassis, and press into place.
CAUTION: Installing the rubber feet on the switch is recommended to help prevent the
switch from accidentally sliding off the table or bench.
3. Connect the power cables to the SAN Switch 2/32 power connectors and to a
power outlet. Ensure the power cable is routed so that it is not exposed to stress.
4. Turn on the power to the switch (flip the AC switch to "1"). The switch
automatically runs a Power On Self-Test (POST).
CAUTION: Do not connect the switch to the network until the IP address is correctly
set. For instructions on how to set the IP address, see "Configuring SAN Switch 2/32
Network Addressing," later in this chapter.
2–6
-
alone Unit
SAN switch 2/32 version 4.0.x installation guide