Opc-Ua Send - Siemens SIMOCODE pro Operating Manual

Parameters
4.4 Outputs
4.4.8

OPC-UA send

Description
In addition to "Cyclic Send," it is possible to transfer a further 16 bits of binary information via
OPC UA.
With the "OPC UA Send" function block, you can specify which information is to be
transferred. The inputs (plugs) of the function blocks must be connected to the respective
sockets.
The "OPC-UA send" function blocks each consist of eight bits (= two bytes, byte 0 and byte 1
for binary information).
A total of two "OPC-UA Send" function blocks are available.
Schematic
The following schematic shows the "OPC-UA Send" function blocks:
Figure 4-58
Settings
Table 4- 57
OPC-UA Send Data
Bytes 0 to 1, bits 0 to 7
180
"OPC-UA send" function blocks
OPC-UA Send Data settings
Description
Setting and resetting of bits by means of any signal (any socket, e.g.
device inputs, send data, status information, events, etc.)
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001