Siemens SIMOCODE pro Operating Manual page 206

Parameters
4.7 Standard functions
Test phases
The following table shows the test phases performed when the "TEST / RESET" button is
pressed for the required length of time:
Table 4- 68 States of the status LEDs / contactor controls during testing
Test phase State
< 2s "DEVICE" LED
"GEN. FAULT" LED
Contactor control
Show QL
2 to 5s "DEVICE" LED
"GEN. FAULT" LED
Contactor control
> 5s "DEVICE" LED
"GEN.FAULT" LED
Contactor control
LED lighted/switched on
1) "Fault" only displayed after 2 s
Test settings
Table 4- 69 Test settings
Test 1 to 2
Input
Test / Reset buttons blocked
206
Without main current
OK Fault
Hardware test / lamp test
orange
Unchanged Unchanged
Results of the hardware test / lamp test
green
Unchanged Deactivated
Relay test
green
Deactivated Deactivated
LED flashing
Description
Activation of the "Test" function block by any signal (any sockets, e.g. device
inputs, communication bus control bits, etc.).
The blue TEST/RESET buttons on the basic unit and the operator panel are
usually intended for acknowledging faults and for performing a device test.
The buttons can be disabled with "TEST/RESET keys disabled". These can then
be used for other purposes. On the operator panel with display, blocking is
carried out via the corresponding menu function. (Default: not disabled)
With main current
OK
1)
green orange
Unchanged
red green
Unchanged
red green
Deactivated
LED flickering
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Fault
green
Unchanged
red
Deactivated
red
Deactivated
LED off
SIMOCODE pro - Parameterize