Siemens SIMOCODE pro Operating Manual page 92

Parameters
4.2 Motor control
Settings
You will find detailed explanations of the settings in Chapter Application selection, settings
and definitions of control functions (Page 66).
Table 4- 16 Dahlander settings
Dahlander
OFF
ОN >
ON >>
FB ON
Non-maintained command mode
Separate fail-safe function from
control function
Saving change-over command
Load type
Feedback time
Execution time
Change-over pause
92
Description
Control command OFF
Connection with any socket, usually with "Enabled control command OFF" socket
Control command ON > (SLOW)
Connection with any socket, usually with "Enabled control command ON >" socket
Control command ON >> (FAST)
Connection with any socket, usually with "Enabled control command ON >>" socket
"Feedback ON" auxiliary control input
Connection with any socket, usually with "Status - current flowing" socket
Deactivated (default setting)
•
Activated
•
Deactivated (default setting):
•
A safety-related tripping by the DM-F modules also affects the SIMOCODE pro
•
control function, avoiding additional follow-on fault messages. This setting is
selected for applications where safety-related tripping directly affects the motor
controlled by SIMOCODE pro.
Activated: A safety-related tripping by the DM-F modules does not affect the
•
SIMOCODE pro control function. This setting is selected for applications where
safety-related tripping does not affect the motor controlled by SIMOCODE pro.
Deactivated (default setting)
•
Activated
•
You can choose between:
Motor (default)
•
Resistive load (see Chapter Application selection, settings and definitions of control
•
functions (Page 66))
Range 0 to 25.5 s (default: 0.5 s)
Range 0 to 6553.5 s (default: 1.0 s)
Range 0 to 655.3 s (10 ms steps) (default: 0.00 s)
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001