Enables And Enabled Control Command - Siemens SIMOCODE pro Operating Manual

Parameters
4.2 Motor control
4.2.1.3

Enables and enabled control command

Enables
Enables, which have to be activated, are assigned to the "ON" and "OFF" control commands
for each control station in every operating mode. That is, depending on the mode, it is
possible to define for each control station whether it is permitted to switch the motor on only,
off only, or on and off. The relevant checkbox
box in SIMOCODE ES.
Diagram of enables and enabled control command
The following diagram shows the "Control Stations" function block and the operating modes:
58
is selected in the "Control stations" dialog
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001