Siemens SIMOCODE pro Operating Manual page 111

Settings
You will find detailed explanations of the settings in Chapter Application selection, settings
and definitions of control functions (Page 66).
Table 4- 22 Positioner control function settings
Positioner
ON <
OFF
ОN >
FB ON
FC
FO
TC
TO
Non-maintained command mode
Separate fail-safe function from control
function
Load type
Feedback time
Execution time
Interlocking time
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Description
Control command ON < (CLOSED) (connection with any socket, usually with
"Enabled control command - ON <" socket)
Control command STOP (connection with any socket, usually with "Enabled
control command - OFF" socket)
Control command ON (OPEN) (connection with any socket, usually with
"Enabled control command - ON >" socket)
Auxiliary control input "Feedback ON" (connection with any socket, usually with
"Status - current flowing" socket)
Auxiliary control input "Feedback CLOSED" (connection with any socket,
usually with the socket of an input to which the limit switch is wired.)
Auxiliary control input "Feedback OPEN" (connection with any socket, usually
with the socket of an input to which the limit switch is wired.)
Auxiliary control input "Torque CLOSED" (connection with any socket, usually
with the socket of an input to which the torque switch is wired.)
Auxiliary control input "Torque OPEN" (connection with any socket, usually with
the socket of an input to which the torque switch is wired.)
Deactivated (default setting)
•
Activated
•
Deactivated (default setting): A safety-related tripping by the DM-F modules
•
is also effected by the SIMOCODE pro control function, avoiding additional
follow-on fault messages. This setting is selected for applications where
safety-related tripping directly affects the motor controlled by
SIMOCODE pro.
Activated: A safety-related tripping by the DM-F modules does not affect the
•
SIMOCODE pro control function. This setting is selected for applications
where safety-related tripping does not affect the motor controlled by
SIMOCODE pro.
You can choose between:
Motor (default)
•
Resistive load (see Chapter Application selection, settings and definitions of
•
control functions (Page 66))
Range 0 to 25.5 s (default: 0.5 s)
Time until the end position is reached.
Range 0 to 6553.5 s (default: 1.0 s)
Range 0 to 255 s (default: 0 s)
Parameters
4.2 Motor control
111