Control Station Settings - Siemens SIMOCODE pro Operating Manual

Parameters
4.2 Motor control
4.2.1.4

Control station settings

Table 4- 6 Control station settings
Control stations
LC
ON <<
ON <
OFF
ОN >
ON >>
PLC/PCS
ON <<
ON <
OFF
ОN >
ON >>
PC
ON <<
ON <
OFF
ОN >
ON >>
Operator panel [OP]
<>/<<>>
ON <
OFF
ОN >
ON >>
Mode selector
S1
S2
60
Description
Activates the control station via any signal (any sockets, but typically device inputs). The
"OFF" plug is 0-active on the control station [LC].
Activates the control station via any signal (any sockets, but typically control bits from the
bus).
Activates the control stations via any signal (any sockets, but typically control bits from the
bus).
Activates the control stations via any signal (any sockets, but typically buttons on the operator
panel)
For switching between the 4 operating modes Local 1, Local 2, Local 3 and remote with any
signals (any sockets, e.g. device inputs, control bits from/via the bus.).
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001