Siemens SIMOCODE pro Operating Manual page 118

Parameters
4.2 Motor control
Settings
You will find detailed explanations of the settings in Chapter Application selection, settings
and definitions of control functions (Page 66).
Table 4- 24 Soft starter with reversing contactor settings
Soft starter with reversing contactor
ОN >
OFF
ON <
FB ON
Non-maintained command mode
Saving change-over command
Separate fail-safe function from
control function
Load type
Feedback time
Execution time
Interlocking time
118
Description
Control command ON > (clockwise) (connection with any socket, usually with
"Enabled control command - ON >" socket)
Control command OFF (connection with any socket, usually with "Enabled control
command OFF" socket)
Control command ON < (counterclockwise) (connection with any socket, usually
with "Enabled control command - ON <" socket)
Auxiliary control input "Feedback ON" (connection with any socket, usually with
"Status - current flowing" socket)
Deactivated (default setting)
•
Activated
•
Deactivated (default setting)
•
Activated
•
Deactivated (default setting): A safety-related tripping by the DM-F modules
•
also affects the SIMOCODE pro control function, avoiding additional follow-on
fault messages. This setting is selected for applications where safety-related
tripping directly affects the motor controlled by SIMOCODE pro.
Activated: A safety-related tripping by the DM-F modules does not affect the
•
SIMOCODE pro control function. This setting is selected for applications where
safety-related tripping does not affect the motor controlled by SIMOCODE pro.
You can choose between:
Motor (default)
•
Resistive load (see Chapter Application selection, settings and definitions of
•
control functions (Page 66))
Range 0 to 25.5 s (default: 0.5 s)
Execution time ≥ Soft run-down time
Range 0 to 6553.5s (default: 1.0 s)
Range 0 to 255 s (default: 0 s)
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001