Siemens SIMOCODE pro Operating Manual page 167

Application examples
● Displaying operating states:
You can define which LEDs are to be used for displaying the operating states (Fault, ON,
OFF, FAST, SLOW...). To do this, connect the desired LED to the respective "QL." lamp
control of the control function.
In many cases, the LEDs are connected with the QL outputs. By referring to Table Active
control stations, contactor controls, lamp controls and status information for the control
functions (Page 119), you can determine which QL outputs are required for which control
functions.
● Transfer of any other information, status information, warnings, faults, etc. to the yellow
LEDs.
Settings
Table 4- 52
OP LED
Green 1 to
Green 4
Yellow 1 to
Yellow 3
1) No function when using the operator panel with display
Defaults depend on the selected application (template): See Chapter Application selection,
settings and definitions of control functions (Page 66).
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Operator panel LED settings
The "OP LED" function block can be activated by any signal (any sockets, e.g.
"motor" operating state feedback).
The "OP LED" function block can be activated by any signal (any sockets, e.g.
displays for status, events, faults).
1)
Description
Parameters
4.4 Outputs
167