Flashing - Siemens SIMOCODE pro Operating Manual

Parameters
4.8 Logic modules
4.8.9

Flashing

Description
If an input signal is pending at its plug, the "Flashing" logic module issues a signal to its
socket, which alternates between binary 0 and 1 at a fixed frequency of 1 Hz. You can use
this to make the LEDs on the operator panel flash, for example. The logic module consists
of:
● one plug
● one logic component
● one socket
In total, 3 "Flashing" logic modules (1 to 3), are available.
Schematic
The following schematic shows the "Flashing" logic modules:
Figure 4-103 "Flashing" logic modules
Settings
Table 4- 94 Flashing settings
Flashing 1 to 3
Input
254
Description
Activation by any signal (any sockets, e.g. device inputs, events, status, etc.)
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001