Advanced Features - Hunter X-Core Owners Manual And Programming Instructions

adVanCed feaTUres ...........................................................................................................

Set Pump/Master Valve Operation
The default is for all stations to have the
master valve/pump start circuit ON. The
master valve/pump start can be set ON
or OFF by station, regardless of which
program the station is assigned.
To program pump operation:
1. Turn the dial to SET PUMP
OPERATION position.
2. Press the or buttons to toggle the
master valve/pump start ON or OFF for
the specific station.
3. Press the button to advance to the next station.
4. Repeat steps 2 and 3 for all necessary stations.
Programmable Rain Off
This feature permits the user to stop all
programmed waterings for a designated
period from 1 to 31 days. At the end of
the programmable rain off period, the
controller will resume normal automatic
operation.
1. Turn the dial to the SYSTEM OFF
position.
2. Press the
button and a 1 will be
displayed and the DAYS LEFT icon will
illuminate.
3. Press as many times as needed to set
the number of days off desired (up to 31).
20
SET PUMP OPERATION
SYSTEM OFF
4. Turn the dial back to the RUN position at
which time, OFF, a number and the DAYS
icon all remain on.
5. Leave the dial in the RUN position.
The days off remaining will decrease at
midnight of each day. When it goes to zero,
the display will show the normal time of day
and normal irrigation will resume at the next
scheduled start time.
Setting Specific Day(s) Off
Programming a No Water Day(s) is useful to inhibit watering on mowing
days, etc. For instance, if you always mow the lawn on Saturdays you
would designate Saturday as a No Water Day so you are not mowing wet
grass.
1. Turn the dial to the DAYS TO WATER position.
2. Enter an interval watering schedule as
described on page 21.
3. Press the button once. MON will
be flashing.
4. Use the button until the cursor is
at the day of the week you wish to set
as a No Water Day.
5. Press the button to set this day
as a no water day. The will illuminate
over this day.
6. Repeat steps 4 and 5 until all desired
event day(s) are off.
RUN
SET DAYS TO WATER