Hunter X-Core Owners Manual And Programming Instructions page 148

address or the sensor selections at anytime, if
changes occur to the system.
• Turn the dial to "Set Sensor Operation." There
is a display page for each Program, allowing
the responses for each sensor to be set. Select
"Suspend", "Pause", or "Off" for each sensor.
• Note that a program may not have both Pause and
Suspend responses. A program cannot be in both
Pause and Suspend at the same time. The responses
will automatically change to agree with the most
recent selection. If you set S1 to Pause, and then set
S2 to Suspend, the S1 will automatically change to
Suspend. It is impossible for a program to be in Pause
and Suspend at the same time.
oTher speCIal deCoder funCTIons (adVanCed feaTures) ......
VIeW DeCODer COnfIG
This allows the controller to search down the two-wire
path and return the configuration of any installed decoder
with an address. It can be used to determine whether
a particular station belongs to a 1, 2, 4, or 6 station
configuration, and can be used to retrieve the setup info
for a specified Sensor Decoder.
•
• Turn the Dial to Advanced Features. Arrow down to
"Decoder Functions." Press the + button.
62
• Once the sensor decoders are configured, the
controller will immediately begin polling the sensor
decoder continuously to monitor the alarms. This may
cause alarm messages until the sensor decoders are
actually installed in the two-wire path. The polling
function can be stopped to prevent false alarms. See
Other Special Decoder Functions (Advanced Features)
on page 62 for more information.
• Arrow down to "View Decoder Config."
Press the + button.
• This is a view-only screen and cannot be used to edit
the decoder.