Hunter X-Core Owners Manual And Programming Instructions page 327

adjusTmenTs and operaTion
Transmitter operation
There is nothing to set up with the
Wireless Rain-Clik
receiver operation
The receiver has two LED lights that indicate
the state of the system.
1.
SENSOR STATUS LED:
RED – Sensor is wet
(watering disabled)
GREEN – Sensor dry
(watering enabled)
YELLOW – Sensor is in
addressing mode
12
.
™
SENSOR BYPASS
SENSOR STATUS
RAIN SENSOR BYPASS
2. SENSOR BYPASS LED:
RED – Rain sensor is bypassed (even though
the sensor is bypassed, the STATUS LED
will continue to alert you of the state of the
sensor (wet or dry).
OFF – Rain sensor is enabled.
FLASHING RED – Indicates that
communication between the transmitter and
receiver was lost.
Note:
When you first apply power to the
receiver, the SENSOR STATUS LED will be RED.
Press the manual test spindle on the transmitter
Red light indicates
sensor is bypassed
for 5 seconds and release the spindle. The
GREEN = Sensor is dry
SENSOR STATUS LED will turn GREEN indicating
RED = Sensor is wet
proper operation.
Press to bypass, press
again to re-enable