Hunter X-Core Owners Manual And Programming Instructions page 142

The display will show the following Reset options:
• Programs: Erases Day schedules, start times, and run
times.
• Flow Totals: Clears the running flow total histories
(they will restart with 0.0 for all entries), only.
• Logs: Clears alarm, controller, and station logs, only.
• Names: Clears all user-programmed names, including
Programs, Stations, and SSGs.
• All Data: Clears all of the above items, and controller
returns to original out-of-the-box programming state.
• Use the up and down arrows to highlight the desired
type of Reset .
• Press the + button to select it.
• A confirmation message will appear. If + is pressed
again, the selection will be reset.
None of the reset functions will erase the Easy Retrieve'
"backup", if one has been made.
deCoder operaTIons (aCC99d VersIons) .................................
Status LEDs
2-wire path
terminals (1-6)
COnneCtInG the 2-WIre PAthS
1. Turn Controller power OFF.
2. If the decoder output module is a replacement for an
existing decoder installation, simply reconnect the
2-wire paths to their screw terminal assignments. If
more than one path has been used, attach the original
red and blue pairs to the red and blue terminals with
the appropriate number.
3. If this is a new installation, or conversion of a
conventional controller to decoder operations:
• Route the red and blue wire paths from the field
up through the wire openings or conduit into the
controller wiring compartment.
• Connect the red and blue 2-wire paths to the decoder
output screw terminals.
• There are two rows of screw terminals on the decoder
output module, one red and one blue, labeled
1-2-3-4-5-6. Each numbered pair represents a
possible 2-wire path to the field (some systems only
use one pair, others may use all 6).
• Connect the red wire from a twisted pair to a
56
4. Turn controller power back ON and test. The Module/
Programming
Port
numbered red terminal, and connect the blue wire
to the blue terminal with the same number. Do not
connect more than one wire to any of the terminals.
Do not mix red from one pair with the blue from
another pair. Keep each pair separate, red to red and
blue to blue, until all pairs are connected to their
numbered terminals.
Line Activity LED on the decoder output module should
light up red for a few seconds. The red light should
then disappear and the Line Status LED on the decoder
output module should be a steady green, with no other
line activity or stations running.