Hunter X-Core Owners Manual And Programming Instructions page 134

To create and use SSGs: In order to create and use
SSGs, the controller must first be placed into the
SSG/Smartstack mode.
1. Turn the dial to the Set Program Overlap Options
position.
2. Use the +/- buttons to select SSG/SmartStack.
3. Turn the dial to any other position to save the setting.
4. Hold down the Information button, and turn the dial
back to the Set Program Overlap Options position.
5. Release the Information button, and the SSG Setup
screen will appear.
6. The first possible SSG will be presented as STA GRP
01, and will display 4 rows (dashed lines in a new
installation, station numbers if they have already
been programmed). Each line is for a station that can
become a member of the SSG.
7. Use the down arrow to go to the first dashed line (or
existing station number).
8. Use the +/- buttons to select a station number. Once
a station has been assigned to an SSG, it is no longer
available for other SSGs, and will not appear as one
of the choices while pressing + or – in other SSGs.
Once a station has been programmed into an SSG,
this station will no longer be available individually as
a single station outside of the SSG. If a station in an
SSG is viewed individually in the Station Run Times
position, the run time will be filled with asterisks
(**:**:**) and the screen will show the SSG to
which the station belongs, instead. No run time may
be entered for an SSG station individually. If a station
has an individual run time in a program, that station
will not be able to be programmed into an SSG.
While entering stations into an SSG, the stations that
already have a programmed run time will be skipped
over, and the only stations with no run time will be
shown.
48
9. Use the down arrow to go to the next station line, to
add another station to the SSG.
10. Include 2, 3, or 4 stations in the SSGs as needed. (It
is possible to create an SSG of only 1 station, but this
defeats the purpose of the SSG- single stations may
be mixed in a program with SSGs, as long as they are
not SSG members.)
11. When the SSG is complete, you can create another
SSG without exiting the dial position.
12. Use the up arrow to move back to the STA GRP
location.
13. Press +/- to select another STA GRP number.
14. Continue to add stations and create SSGs until all
desired groups are created and populated.
15. Turn the dial to any other position to save. The SSG
groups that you have programmed can be found
within the "Set Station Run Times" position after
the last station number in the controller, or by going
backwards from station 1. The same is true for the
"Manual Operation" dial position (the SSG groups
will be found after the highest-numbered individual
station).
You may run a station individually, even if it has been
programmed in an SSG, by selecting the "One Station"
manual in the Manual Operation dial position, and then
selecting the specific station you would like to run.
You may also run a station individually that has been
programmed in an SSG by using a remote control.
EDIT AN SSG
Changing or deleting an existing SSG is done from the
same Extended Feature.