Wireless rain-Clik
Wireless rain-Clik
receiver
™
1. Bypass Button – Allows automatic or manual
watering when the sensor is active.
2. Sensor Bypass LED – Indicates when sensor
has been bypassed.
3. Sensor Status LED – Used to indicate the
status of the sensor.
4. Radio Antenna – Receives a wireless signal
from the transmitter up to 800 ft. (275m) It
is recommend that the antenna be oriented
vertically.
5. AC Power Wires – The two yellow wires
are attached to a 24 VAC source from
the controller.
6. Sensor Wires – The sensor wires are
attached to either the sensor terminals in the
controller or in-line with the valve common
wire.
Blue/White Wires (used for normally closed
sensor applications)
ComponenTs
™
7. Rubber Cover – Used to protect the receiver
4
2
1
Blue/Orange Wires (used for normally open
sensor applications)
when mounted in outdoor locations.
Red light indicates
SENSOR BYPASS
sensor is bypassed
3
SENSOR STATUS
GREEN = Sensor is dry
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
5
Yellow to 24 VAC Power
6
Blue
White
Orange
7
Blue/White wires to normally
closed sensor terminals
Orange/White wires to normally
open sensor terminals
5