Hunter X-Core Owners Manual And Programming Instructions page 167

wait period has elapsed or the radio carrier signal stops,
with no more tones.
A longer DTMF wait allows slower typing speeds of the
command on the radio. The trade-off is that the longer
wait means that it will take longer for the action to be
carried out (in other words, if the Wait is 5 seconds, it will
be 5 full seconds after the command has been sent before
the sprinkler turns on).
This setting is not shown if there is no radio. This setting
does not affect ICR remote commands.
Mr DefAult run tIMe (rADIO Only)
Default = 30 Minutes. This sets the automatic run time
for any station or SSG that is started by a Maintenance
Radio command, if no run time has been specified in
the On command. It is possible to turn a station or SSG
on without specifying a run time, and this setting will
automatically turn them off after the specified time if they
are not turned off by an Off comand. The Default Run Time
can be changed in 1 minute increments up to a maximum
of 60 minutes. This setting is not shown if there is no radio
and does not affect ICR remote commands.
MODeM tyPe
Indicates presence of a telephone modem in the Com
module. This display is informational and cannot be
changed from the Com module.
COuntry CODe
If a telephone modem is detected, the country code may
need to be changed to work with regional data modem
requirements. The default setting is "0" and for most
countries countries this is the correct selection.
81
If your country appears on the following list, change the
code display to the number shown:
Country
Australia
Czech Republic
Hong Kong
Hungary
India
Indonesia
Israel
Japan
North Korea
Malaysia
New Zealand
Philippines
Poland
Singapore
Slovenia
South Africa
Vietnam
To change the country code, press Enter and the code will
be highlighted. Use the + or – buttons to select the code,
and press Enter. The code will now be set.
hWIM
Indicates presence of a Hardwire Interface Module
(ACC-HWIM) installed in the controller. "None" indicates
no HWIM has been found, "Installed" indicates that the
HWIM is installed and has been detected. This display
is informational and cannot be changed from the Com
module.
enter DIAGnOStICS
To use the built-in communications diagnostics, press the
Enter button at this display.
This will allow you to select from the following diagnostic
functions (use the up or down arrow buttons to move
through the choices).
Communications Status display [MOD RAD HW]
Pressing the left arrow button at any time will show a
status display for communications, showing transmit and
receive activity for each communications type. The display
shows: MOD RAD HW #, indicating Modem, Radio,
Hardwire, and number of data packets sent.
Under each item MOD, RAD, and HW, the letter T shows
transmit activity and R shows receiving data for that
communications component. The symbol * shows other
radio traffic ("carrier detect").
Code
2
3
1
1
1
1
1
4
1
1
5
1
1
1
1
6
1