Hunter X-Core Owners Manual And Programming Instructions page 321

mounTing The reCeiver
Wiring the receiver to Your Controller
Using the hardware supplied, mount the
receiver to the wall next to the irrigation
controller. It is recommended that the receiver
be installed away from sources of electrical
interference and metal objects to maximize
communication range. Make sure to attach
the rubber cover under the receiver when
installing the receiver in an outdoor location.
Warning:
This unit is designed to be installed
in conjunction with 24 VAC circuits only. Do not
use with 110 or 220 VAC circuits.
6
Wiring the receiver to a hunter srC
1. Attach the two yellow wires to the
AC terminals.
2. Attach the blue wire to the RS terminal.
3. Attach the white wire to the C terminal.
4. Attach the valve common wire to the
RS terminal.
SENSOR BYPASS Red light indicates
sensor is bypassed
SENSOR STATUS GREEN = Sensor is dry
AC
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
Y
Y
B
W
O
AC R RS C 1 2 3
Common Wire
to all Valves
Used for normally open
sensor applications