Hunter X-Core Owners Manual And Programming Instructions page 192

ovErviEW oF DECoDEr progrAMMiNg
6. The display will briefly show "Reading DONE" when the
module has completed identification of the decoder.
7. If the decoder red/blue wires are not fully inserted into the
module, or if the decoder is defective, a "Reading ERROR"
message will be displayed.
8. Once the module has recognized the decoder, it is now
ready to be programmed. Brackets [ ] indicate the station
number for the decoder output. There will be two sets of
brackets for a two-station decoder. (There may already be a
number within the brackets indicating that the decoder has
been previously programmed.)
A new decoder out of the box will be set to station 00, and
new DUAL-2 decoders will have both stations set to 00.
Use the  buttons to select or change the station number
9.
you would like to program into the decoder.
10. Press the  button to begin the automatic programming
procedure.
11. The display will indicate when programming has been
completed by showing "Programming DONE". If the
decoder has been accidentally disconnected or
malfunctions, the display will show "Programming ERROR".
This means the decoder was not programmed (check
connection, and try again).
12. If a two-station decoder is being programmed, use the 
button to navigate to the second set of brackets [ ] which
indicate the station number for the #2 decoder output. Use
the  buttons to select the station number you would like
to program.
13. Press the  button once and the module will conduct the
automatic programming procedure for the #2 decoder
output.
14. Again, if the programming (of the decoder) is successful, the
display will show "Programming DONE".
15. When the decoder and stations have been programmed,
the module display will return to the ready mode. It is
recommended that you write the station numbers for each
decoder output on the label provided on each decoder.
13