Hunter X-Core Owners Manual And Programming Instructions page 139

one TouCh manual sTarT .........................................................
One-Touch Manual Program Start with Station Advance
(right arrow button)
With dial in Run, press and hold the right arrow button
approximately 3 seconds to enter Manual Program start
mode.
Choose desired program with Programs button, and wait.
Program will start in approximately 3 seconds, if no other
buttons are touched. The controller will run the selected
program until it is finished. Note that the program will
still run automatically at the scheduled start time (if it is a
watering day).
You have the option of beginning on a higher-numbered
station or SSG, if you do not wish to run the whole
program.
Before the program starts, use the down arrow button to
move to the station number in the display.
Press the + button to move to a higher-numbered station
or SSG, and wait approximately 3 seconds.
The program will begin on that number. It will not "circle
around" and water the lower numbered stations. It will
begin at the number you selected, continue to the end,
and stop.
Once the Program is started, press the right arrow again
to advance, to the next highest-numbered station (or
SSG) in the Program with a run time. You may continue to
manual operaTIon dIal posITIon.............................................
This dial position enables immediate operation of either
a single station (including P/MV1 or P/MV2), or an
Automatic Program. It can also be used to start an SSG or
a Custom Manual Program (if these optional items have
been created).
53
advance through all the stations/SSGs in a Program.
• If the controller is running that last (highest
numbered) station or SSG with a run time in the
selected program, and the right arrow button is
pressed again, the station will be stopped and no
new stations will be started (the program will have
completed).
• The Station Advance feature does not work in reverse.
You may advance, but you may not step back down
through the lower numbered stations and SSGs.
• SSG groups are advanced as a group. If the SSG
running contains 1, 2, and 3, and the advance button
is pressed, 1, 2, and 3 are all stopped and replaced by
the next station or SSG in the program. If the next item
was an SSG containing 3, 4, and 5, then stations 1,2,
and 3 will be replaced by stations 3, 4, and 5.
• You may start multiple programs with the One-Touch
Manual Program Start. Start the first program and
wait for it to begin. Then press and hold the right
arrow again. Until you change programs, the display
will show "CANNOT RUN MANUAL. This program is
already running."
• Press the Programs button to select another program
and wait about 3 seconds for the program to begin.
• Stack and Overlap settings are observed in Manual
Starts. You may only run multiple programs manually
if they are all set to Overlap.
• Turn the dial to the Manual Operation position.
• Use the +/- buttons to switch between Manual
Program, or Manual One Station.