Hunter X-Core Owners Manual And Programming Instructions page 151

InStAllAtIOn
• Mount the Solar-Sync sensor according to the sensor
instructions. The sensor must be within 200ft/60m of
the controller, and must be installed outdoor in full sun.
• The sensor should be allowed to receive the
maximum sunlight possible at all times of day.
Some locations may be shaded by trees or buildings
during mornings or afternoons. Anticipate this when
choosing the location. Maximum sunlight exposure
during daylight is preferred.
• Route the wires into the controller cabinet through a
low voltage conduit opening.
• Connect the wires according to color code to the ET
terminals. The power and signals are DC, and the
wires must be connected to + (Green) and – (Black)
correctly. If the wires are reversed, the controller will
not be able to receive signals from the sensor.
• All connections should be made inside the controller
cabinet. If this is not possible, use waterproof
connectors for any outside connections.
• The Solar-Sync sensor cannot be installed at the same
time as a Hunter ET Sensor. Only one sensor can be
connected to the ET terminals.
65
SetuP
• When the installation is completed, turn the dial to the
Advanced Features position. Select the ET Functions
option (if ET Functions does not appear in the menu,
the master module must be updated).
• Select the ET Operations option.
• The screen will display the ET Operation page. Set the
Use ET option to "Yes" and the ET Mode to "SOLAR
SYNC"
• Press the BACK button to return to the ET Functions
menu.
• Select the Solar Sync Setup option.
• The screen will display the Solar Sync setup page.
• The Solar-Sync Adjust value will show 100%* until the
first midnight (this cannot be changed).
• At midnight, the Solar Sync Adjust will change to 80%
or greater, based on the sensor. The asterisk
disappears after a full 24 hours of sensor data has
been collected.