Hunter X-Core Owners Manual And Programming Instructions page 324

mounTing The reCeiver
normally open sensor applications
A few controllers on the market require
normally open rain sensors. To attach the
receiver to this type of controller, attach the
blue and orange wire to the sensor input.
Controllers with 24 vaC solenoids and
a booster pump
1. Locate the common wire to the solenoid
valves and the common wire to the pump
relay. If these two wires are connected to
the "common" terminal on the controller,
disconnect both of them.
2. Twist together these wires along with one of
the wires from the Wireless Rain-Clik
secure with a wire nut.
3. Attach the other wire from the Wireless Rain-
Clik receiver to the "common" terminal on
™
the controller.
AC AC
Line-Out (to Pump)
and
™
Note:
not proceed if 115 VAC.
Pump
or
MV C 1 2 3 4
Line-In
Normally-
Open Relay
Common
Wire to All
Valves
The pump circuit output must be 24 VAC. Do
SENSOR BYPASS Red light indicates
sensor is bypassed
SENSOR STATUS GREEN = Sensor is dry
RED = Sensor is wet
Press to bypass, press
again to re-enable
RAIN SENSOR BYPASS
Y
Y
W
B
Solenoid
Valves
9