Hunter X-Core Owners Manual And Programming Instructions page 162

First, select the Event Day you wish to view (1, 2, or 3).
Then press the right arrow button to view the downloaded
events for that day. Use the down arrow to scroll through a
large list of events.
Note: You cannot edit or change individual station events.
Event Count: This will show the total number of
downloaded events. It is useful for verifying that an entire
System Event download was received by the controller.
The event count totals should match the total number of
events in the Surveyor software.
76
Delete Events: This will permanently delete all downloaded
System Events. The controller will not be able to irrigate
until it has received a new System Event download, or until
it is switched back to the FCP mode and FCP programs are
created.
Types of Events: System Automatic Events are shown in
displays as "SAE". They are the individual station starts
that have been scheduled by central software (Surveyor),
and downloaded to the controller.
SAEs are the primary operating mode of Surveyor's
event-based irrigation scheduling. They may not be
created or edited at the controller. They are only created
when Surveyor applies flow processing to an event-type
system program at the computer, and downloads the
result to the controllers.
System Manual Events are displayed as "SME". These
are manual starts sent to the controller by an operator at
the central computer. They are not part of the automatic
irrigation but are started by Surveyor software when the
controller is in Event Mode.