Connecting To The Hunter Et System - Hunter X-Core Owners Manual And Programming Instructions

NOTE: Any extension of the wiring on the
SmartPort may result in an error message in
®
the controller display and possible malfunction
of the remote unit due to radio interference. In
some situations, lengthening of the harness may
work fine, in others it may not work at all (it is
site specific). In either case, extending the wiring
harness should be done using shielded cable to
minimize the possible effects of electrical noise.
For easiest installation, order a new Hunter
SmartPort shielded cable wiring harness (part
#SRR-SCWH) with a full 25 feet of shielded cable.

ConneCTInG To THe HUnTer eT sYsTeM

The Hunter ET System allows irrigation programs to be created
automatically, based on local climate conditions. These programs are
then loaded into the controller and run automatically. ET System uses a
sensor to determine the local "evapotranspiration" (ET) rate of turf and
plants. The result is a new, water-efficient irrigation program every water
day, based on local weather conditions. For more information on the ET
System, contact your local Hunter dealer.
Indoor Installation Outdoor Installation
(Temporary Connection
of Receiver Only)
ET MODULE
Controller
Receiver
ET SENSOR
9