Hunter X-Core Owners Manual And Programming Instructions page 328

adjusTmenTs and operaTion
bypassing the sensor
The sensor may be bypassed by using the
built in bypass feature on the receiver. To
bypass the sensor, press the SENSOR BYPASS
button on the receiver. The bypass status light
will turn red when the sensor is bypassed.
Pressing the SENSOR BYPASS button again
will re-enable the sensor and the sensor
bypass light will go out.
setting the Transmitter address at the
receiver
Each transmitter is produced with a unique
address. A receiver must learn this address
to work with that transmitter. This step is only
necessary if transmitters and receivers are
purchased separately.
Note:
Units purchased as a kit will already have
their communication address preset. No addressing
is necessary, however, if the receiver or transmitter is
replaced you need to reset the address.
13