Connecting A Hunter Remote Control - Hunter X-Core Owners Manual And Programming Instructions

ConneCTInG a WeaTHer sensor (continued) ..............................................................
Testing the Weather Sensor
The Pro-C provides simplified testing of a rain sensor when the sensor is
wired into the sensor circuit.You can manually test proper operation of
the rain sensor by running a MANUAL ALL STATIONS cycle by activating
the system using the ONE TOUCH MANUAL START (see page 20). During
the Manual Cycle, pressing the test button on the Mini-Click will interrupt
watering.
ConneCTInG a HUnTer reMoTe ConTrol (not included) .........................................
The Hunter remotes make it
possible for you to operate the
system without having to walk
back and forth to the controller.
The SmartPort connector creates
a simple interface for quick and
easy connection of a Hunter
remote to a Hunter controller.
(SmartPort connectors are
included with Hunter remotes)
To install the SmartPort
connector
1. Install a ½" female threaded "Tee" in the field wiring conduit
approximately 12 feet (3.7 meters) below the Pro-C.
2. Feed the red, white, and blue wires of the harness through the base
of the "Tee" and into the wiring compartment as shown.
To Controller
/ " Thread
1
2
Pre-assembled Assembled
NOTE: A manual single station cycle will override the
sensor to allow manual operation when the sensor is
active.
3. Screw the SmartPort harness housing
into the "Tee" as shown.
4. Attach the red wire to the bottom most
AC1 screw slot, attach the white wire to
the upper AC2 screw slot and attach the
blue wire to the screw slot marked REM.
The SmartPort is now ready for remote
control use. Please refer to the Hunter
remote control owner's manual for further
information or contact your local Hunter
distributor for ordering information.
Blue
White
Red
9