MacDon R85 Assembly Instructions Manual page 95

8. Place wooden blocks (A) under header cutterbar and
header support.
9. Disengage header safety props.
CAUTION
Check to be sure all bystanders have cleared the area.
10. Start engine, and lower header onto blocks so that
header lift linkage (A) lifts at windrower leg and off
of shims.
11. Shut down engine, and remove key.
12. On the high side linkage (A), remove nut, washer, and
bolt (C) that attach shims (B) to link.
13. Remove one or both shims (B), and reinstall the
hardware (C).
14. Raise header approximately 150 mm (6 in.) off ground,
and check level of header.
15. If additional levelling is required, install the removed
shim on the opposite linkage (low side).
NOTE:
Float does NOT require adjustment after
levelling header.
214367
PERFORMING PREDELIVERY CHECKS
87
A
Figure 4.12: Wooden Block Under Header
Support
Figure 4.13: Header Lift Linkage
C
B
Figure 4.14: Header Lift Linkage: Top View
A
A
Revision A