Predelivery Checklist - MacDon R85 Assembly Instructions Manual

Predelivery Checklist

Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are
required, refer to the appropriate page number in this manual. The completed Checklist should be retained by
either the Operator or the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Header Serial Number:
Table .16 Predelivery Checklist
ü ü Item
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
Check for loose hardware. Tighten to required torque if
applicable.
Check main drive belt tension.
Check auger drive belt tension.
Check header angle. Set center-link to middle of
adjustment range.
Check header float: 426–471 N (95–105 lbf).
Check if header is level.
Check if side forming shields are evenly set to desired
position.
Check if rear fluffer deflector is about halfway down.
Check if swath baffle lever is set about halfway.
Check if gauge rollers/skid shoes are evenly set.
Check that bevel gearbox lube level.
Check if bevel gearbox breather is installed.
Check conditioner roll timing gearbox lube level.
Check if conditioner roll timing gearbox breather is
installed.
214367
Reference
—
5.1 Torque Specifications, page 97
4.1 Checking Drive Belts, page 81
4.1 Checking Drive Belts, page 81
3.11 Attaching Header to an M Series
Windrower, page 31
4.2 Checking Header Float: M200 and M205
Windrowers, page 83
4.4 Checking Header Level, page 86
3.10 Installing Forming Shield, page 28
3.10 Installing Forming Shield, page 28
3.7 Unpacking Curtains, page 18
4.6 Checking Gauge Rollers or Skid Shoes,
page 91
4.7 Preparing the Bevel Gearbox, page 92
4.7 Preparing the Bevel Gearbox, page 92
4.8 Preparing the Conditioner Roll Timing
Gearbox, page 93
4.8 Preparing the Conditioner Roll Timing
Gearbox, page 93
111
Revision A