Installing Forming Shield - MacDon R85 Assembly Instructions Manual

3.10 Installing Forming Shield

To install the forming shield, follow these steps:
1. To ease forming shield installation, remove header from windrower (if attached). Refer to your windrower
operator's manual for instructions.
2. Retrieve plate (A) and attachment hardware from
forming shield bundle.
NOTE:
Hardware is supplied with forming shield bundle.
3. Attach plate (A) to windrower leg with two 1/2 x 5-1/4 in.
hex bolts (B) and nuts. Repeat for opposite leg.
IMPORTANT:
Plate (A) is shown in standard position. If installing
double windrow attachment (DWA), install plate in
inverted position.
4. Install a 1/2 x 4 in. hex bolt (C) with spacer (D) and nut
on each plate. Hardware is supplied with forming shield
bundle.
5. Remove the two clevis pins (A) from forming shield
forward end.
214367
ASSEMBLING THE HEADER
Figure 3.42: Attaching Plate to Windrower Leg
Figure 3.43: Clevis Pin at Forward End of
Forming Shield
28
A
D
C
A
B
Revision A