MacDon R85 Assembly Instructions Manual page 38

8. Lift the aft end of the forming shield and attach
straps (B) to pins (A) on windrower frame. Install
washer and hairpin to secure strap. Use the middle hole
and adjust height to suit the crop.
9. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
10. Adjust rear fluffer deflector (C) to middle position.
Loosen handles (B) if required.
214367
ASSEMBLING THE HEADER
Figure 3.46: Attaching Forming Shield to
Windrower Frame
Figure 3.47: Adjusting Forming Shield
30
B
C
A
B
A
Revision A