Preparing The Conditioner Roll Timing Gearbox - MacDon R85 Assembly Instructions Manual

4.8 Preparing the Conditioner Roll Timing Gearbox

To prepare the conditioner gearbox and check the oil level, follow these steps:
1. Open the driveshield.
2. Adjust the header height and angle until the top of the
conditioner gearbox (A) is level with the ground (B).
3. Cut cable ties and remove bags (A) and (B) from the
breather pipe elbows.
4. Remove the plug from breather pipe (A) and replace it
with the breather cap in bag. Discard bag and plug.
5. Remove check plug (B) to check oil level. Oil should
slightly run out when removed.
NOTE:
If the oil does not run out, top up with a 75W90 synthetic
gear lubricant with high thermal and oxidation stability
conforming to API GL-5 minimum (SAE J2360
preferred) specifications such as Traxon E Synthetic
75W90 gear oil.
214367
PERFORMING PREDELIVERY CHECKS
93
B
Figure 4.27: Conditioner Gearbox
Figure 4.28: Bevel and Conditioner Gearbox
A
B
Figure 4.29: Conditioner Gearbox
A
B
A
Revision A