MacDon R85 Assembly Instructions Manual page 16

5. Position auger pan (A) against cutterbar lugs and install
four 1/2 x 3.5 in. long bolts (B) and lock nuts. Do NOT
fully tighten.
6. Check and make sure that auger pan is oriented
as shown.
7. Check and make sure that center pan is position evenly
before tightening. Tighten enough so nut is locked and
pan can still pivot.
8. Retrieve plates (C) from hardware bag, and install as
shown at each end of pan with four 1/2 x 1.0 in.
bolts (D). Tighten hardware.
NOTE:
There may be a gap between the cutterbar lugs and the
auger pan when tightening the hardware. The hardware
does not need to pull the auger pan flush against the
cutterbar lugs.
214367
ASSEMBLING THE HEADER
Figure 3.3: Auger Pan Installed
8
A
B
A
D
C
Revision A