Greasing Procedure; Lubrication Points - MacDon R85 Assembly Instructions Manual

3.15.2 Greasing Procedure

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
The greasing points are marked on the machine by decals showing a grease gun and grease interval in hours
of operation.
1. Wipe grease fitting with a clean cloth to avoid injecting
dirt and grit.
2. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. If fitting will not take grease, remove and clean
thoroughly. Also, clean lubricant passageway. Replace
fitting, if necessary.

3.15.3 Lubrication Points

To identify the various locations that require lubrication, refer to the following illustrations.
NOTE:
Use high temperature extreme pressure (EP2) performance with 1% max molybdenum disulphide (NLGI grade 2)
lithium base except where noted.
214367
ASSEMBLING THE HEADER
Figure 3.158: Grease Interval Decal
77
Revision A