Attaching Hydraulics And Electrical Connections; Attaching Hydraulic And Electrical Components: M205 Windrowers - MacDon R85 Assembly Instructions Manual

3.13 Attaching Hydraulics and Electrical Connections

The procedure for attaching the header hydraulic and electrical connections depends on the windrower model.
Refer to the appropriate procedure:
•
3.13.1 Attaching Hydraulic and Electrical Components: M205 Windrowers, page 56
•
3.13.2 Attaching Hydraulic and Electrical Components: M200 Windrowers, page 61
•
3.13.3 Attaching Hydraulics and Electrical: M1240 Windrowers, page 67

3.13.1 Attaching Hydraulic and Electrical Components: M205 Windrowers

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
NOTE:
Factory-installed hard plumb connections are ideal for attaching an R85 disc header's hydraulics on an M205
windrower. If an auger header or draper header will also be used on a disc header-ready M205 windrower, quick
couplers can be ordered and installed to make switching between these headers easier
Routing hydraulic hose bundle from header to windrower:
1. Move windrower left (cab-forward) platform (A) to
OPEN position. For instructions, refer to the windrower
operator's manual.
1. Order two kits (MD #B5497) for use on an M205 windrower factory-configured for a disc header only. Order one
kit (MD #B5497) for use on an M205 windrower factory-configured for auger and draper headers.
214367
ASSEMBLING THE HEADER
Figure 3.115: Windrower with Left Platform in
Open Position
56
1 .
A
Revision A