MacDon R85 Assembly Instructions Manual page 93

3. Press rotary scroll knob (A) on HPT to display the
QuickMenu system.
4. Rotate scroll knob (A) to highlight header float icon (B)
and press scroll knob to select.
5. Turn scroll knob (A) to highlight left (B) or right (C) float
and press knob (A) to activate selection.
6. Rotate scroll knob (A) to adjust float setting and press
knob when finished. Float is now set.
IMPORTANT:
Float adjustments of 1.0 (out of 10) change the header
weight at the cutterbar by approximately
91 kg (200 lb.). Adjust float in increments 0.05 to
optimize field performance.
7. Use soft key 3 (D) to remove/resume float and deck
position to previous setting for the attached header.
214367
PERFORMING PREDELIVERY CHECKS
85
B
Figure 4.8: HPT Run Screen
B
C
Figure 4.9: HPT Left/Right Float Settings
A
A
D
Revision A