MacDon R85 Assembly Instructions Manual page 76

3. Route hose bundle (A) from header to under
windrower frame.
NOTE:
Route hoses as straight as possible and avoid rub/wear
points that could damage hydraulic hoses.
4. Insert pin (B) into hole (C) in windrower frame, and
place hose bundle on support (D).
5. Remove protective plugs (A) from ends of
hydraulic hoses.
6. Use a clean rag to remove dirt and moisture from the
couplers.
7. Disconnect hose (A) from windrower receptacle (B) and
place in storage cup (C) on multicoupler.
NOTE:
R85 hoses can be connected with either quick-disconnect or hard plumbed fittings. Refer to Step
quick-disconnect hydraulic connections, and to Step
214367
ASSEMBLING THE HEADER
Figure 3.140: Hose and Electrical Routing
Figure 3.141: Protective Shipping Plugs on R85
Hydraulic Hoses
Figure 3.142: Knife Drive Hose
9, page 69 for hard plumbed hydraulic connections.
68
C
B
D
A
A
C
A
B
8, page 69 for
Revision A