MacDon R85 Assembly Instructions Manual page 33

8. Assemble side deflectors (C) to cover with 5/8 x 10 in.
bolt (B), jam nut (E), washer (D), and nut (A).
9. Tighten flange nut (A) enough to hold deflectors (C) in
position, but still allow deflectors to move.
10. Tighten jam nut (E) against cover while holding bolt (B).
11. Remove lynch pin (A) from adjuster rod (B), and
position rod in hole in side deflector (C). Secure with
lynch pin (A).
12. Repeat for other deflector.
214367
ASSEMBLING THE HEADER
Figure 3.36: Forming Shield: Side Deflectors
Figure 3.37: Positioning Adjuster Rod
25
B
D
C
B
C
E
A
A
Revision A