MacDon R85 Assembly Instructions Manual page 56

17. Engage safety prop on lift cylinder as follows:
a. Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b. Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder piston
rods. If safety prop does not engage properly, raise
header until prop fits over the rod.
18. Install clevis pin (A) through support and foot, and
secure with hairpin (B). Repeat for opposite side.
IMPORTANT:
Ensure clevis pin (A) is fully inserted and hairpin is
installed behind bracket.
19. Disengage safety prop by turning lever (A) downward to
raise safety prop until lever locks into vertical position.
NOTE:
If safety prop will not disengage, raise header slightly.
20. Repeat for opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
214367
ASSEMBLING THE HEADER
Figure 3.93: Cylinder Safety Prop
Figure 3.94: Header Support
Figure 3.95: Cylinder Safety Prop
48
B
A
A
A
Revision A