MacDon R85 Assembly Instructions Manual page 45

CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
3. Relocate pin (A) in frame linkage as required to raise
the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
214367
ASSEMBLING THE HEADER
Figure 3.63: Ground Speed Lever
Figure 3.64: Hydraulic Center-Link
Figure 3.65: Header Support
37
A
B
A
B
A
Revision A