Opening The Driveshield: Export Headers; Closing The Driveshield: Export Headers - MacDon R85 Assembly Instructions Manual

Opening the Driveshield: Export Headers

Follow these steps to open the driveshield on export headers:
1. Release rubber latches (A).
2. Insert a screwdriver (or equivalent) through hole in
shield (B) and into the notch in latch (C) and
disengage latch.
3. Open driveshield (D).

Closing the Driveshield: Export Headers

Follow these steps to close the driveshield on export headers:
1. Lower shield (C) so that pins at lower end of shield
engage holes in the lower panel, and latch (B) re-
engages the driveshield.
2. Engage rubber latches (A).
214367
ASSEMBLING THE HEADER
Figure 3.156: Driveshield
Figure 3.157: Driveshield
76
A
C
D
A
B
C
B
Revision A