MacDon R85 Assembly Instructions Manual page 67

4. Position the lock onto the couplers so that retainer (A)
rests under the fitting next to the sleeve on each
coupler.
NOTE:
The retainer can be adjusted by loosening bolts (B).
Tighten bolts after adjusting.
5. Lower holder (A) onto sleeves (B) so that the flats are
positioned on the holder.
NOTE:
Holder can be adjusted by loosening bolts (C). Tighten
bolts after adjusting.
6. Insert lynch pin (A) to secure the lock.
7. Attach case drain hose coupler at (B).
8. Proceed to Step 5, page 60
214367
ASSEMBLING THE HEADER
and Step 6, page 61.
Figure 3.120: Hydraulic Couplers with
Coupler Lock
A
B
Figure 3.121: Hydraulic Couplers with
Coupler Lock
Figure 3.122: Hydraulic Couplers with Case
Drain Hose
59
A
B
C
B
A
Revision A