Installing Swath Baffle Lever - MacDon R85 Assembly Instructions Manual

3.6 Installing Swath Baffle Lever

1. Retrieve adjuster plate and hardware previously
removed from shipping stand (in
Shipping Stands, page
2. Position adjuster plate (A) over holes on side deflector,
and install bolts (E) and nuts. Do NOT tighten.
3. Remove bolt (B).
4. Remove lynch pin from clevis pin (D), and remove
clevis pin from lever (C).
5. Move swath baffle lever (C) to middle hole in
bracket (A), and reinstall clevis pin (D) through lever
and bracket.
6. Secure with lynch pin.
7. Tighten bolts (G).
NOTE:
Baffle position may need to be adjusted for proper pin
engagement. Loosen bolts (E), and adjust bracket (F)
and baffle as required. Tighten bolts (E).
8. Reinstall nut and bolt (B).
214367
ASSEMBLING THE HEADER
3.5 Removing
13).
A
Figure 3.19: Adjuster Plate and Swath
Baffle Lever
A
F
E
Figure 3.20: Adjuster Plate and Swath
Baffle Lever
17
B
E
D
C
D
B
G
C
Revision A