Assembling Forming Shield - MacDon R85 Assembly Instructions Manual

3.9 Assembling Forming Shield

1. Unpack and remove shipping material from side
deflectors (A).
2. Remove hardware bag (B).
3. Open the hardware bag.
4. Install rubber strap (A) to the side bracket (B) using
bolt (C), washer (D), and nut (E).
5. Repeat for the other side.
6. Lay cover (A) upside down on a flat surface.
7. Install the center deflectors (B) using three bolts and
nuts (C) on each side.
NOTE:
The narrow end of deflector (B) faces the front, and the
deep end faces the rear.
214367
ASSEMBLING THE HEADER
Figure 3.33: Forming Shield in Shipping
Configuration
Figure 3.34: Forming Shield Cover Right
Side Up
Figure 3.35: Forming Shield Cover
Upside Down
24
B
A
A
C
B
A
E
D
B
C
Revision A