MacDon R85 Assembly Instructions Manual page 54

NOTE:
If not prompted by the HPT display to remove header
float, remove header float manually by doing the
following:
3. Press rotary scroll knob (A) on Harvest Performance
Tracker (HPT) to highlight QuickMenu options.
4. Rotate scroll knob (A) to highlight HEADER FLOAT
symbol (B), and press scroll knob to select.
5. On Float Adjust page, press soft key 3 (A) to remove
the header float.
NOTE:
If the header float is active, the icon at soft key 3 will say
REMOVE FLOAT; if header float has been removed, the
icon will say RESUME FLOAT.
6. Press HEADER DOWN switch (E) on the ground speed
lever (GSL) to fully retract header lift cylinders.
7. Press REEL UP switch (B) on the GSL to raise the
center-link until the hook is above the attachment pin on
the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
214367
ASSEMBLING THE HEADER
Figure 3.87: HPT Display
Figure 3.88: HPT Display
Figure 3.89: GSL
A - Reel Down
C - Header Tilt Down
E - Header Down
46
B
F
C
E
B - Reel Up
D - Header Tilt Up
F - Header Up
A
A
B
A
D
Revision A